Tips on Installing Your Gutter Guard w/ Drip Edge Adelaide

A gutter guard w/ drip edge Adelaide also called a leaf guard, is an integral part of your gutters, protecting the roof and providing for maximum aeration. If you have a modern house, the system is likely to be a combination of hardware such as a metal gutter guard and a leaf guard which attach to the gutters and cover the edges. If you have an older home, the hardware may not have been changed so you will need to look for a new gutter guard that fits your gutters.

 

Installing a new gutter guard can be quite tricky. Many people think that they only need to drill holes through the eaves to install them, but that is not necessarily true. If you have an older home, you may even want to consider replacing your gutters and a gutter guard w/ drip edge Adelaide at the same time. This is because this will ensure that all of the debris is collected together and moves down the guttering in one fell swoop.

 

You will need to inspect all of the old hardware. There may be a lot of screws and brackets that have been bent or broken. In addition, there could be a lot of rust that has built up over the years. If you are trying to use some metal parts to mount the new guard to the gutters, you will want to check to make sure that all of the screws fit into the slots.

 

Another thing that you should check when you are installing your gutter guard w/ drip edge Adelaide is that the screws are tightly tightened. If the screws aren’t tightened all the way, you may end up damaging the whole gutter system.

 

Once you have the new gutter guard installed, you will need to run some cable down from the top of the gutter. You will want to do this from the side where the gutter is situated and then attach it to the new guard. The cable will have to be at least two inches above the surface of the gutter. This will ensure that the gutter guard is firmly installed and you won’t have any gaps between the two when the water runs through.

 

Once the cable is attached, you can slip on the new guard. You don’t want to install the new guard so that it is visible above the water level because you’ll end up getting soaked in the rain falls in through the gaps between the gutters. If you install it right, it will look great, and you won’t have to worry about it getting wet.